Remember the 'painting station' I used for my CM Storm Spectre worklog a while ago? That was a generic case I had, and now I'm going to give it a re-birth (=
Looks pretty SHIT yes?
Yes, the bottom is colored a glossy red because I painted case fans on it before (haha...)
To clarify some information I'm going to measure its dimensions.
LENGTH: 44.5cm
WIDTH: 20.4cm
HEIGHT: 43cm
So it's (LXWXH) 44.5x 20x 43, this isn't too bad for a crap generic case.
The stuff that comes with it is the top panel (I screwed the rivets out, as I said it was supposed to be a PAINTING STATION) and a single sidepanel, I lost the other one LOL.
Both parts installed:
It looks pretty sweet to me, though it will look like a PIECE OF CRAP to you guys. i'll make it much better.
Another EXCELLENT point about this
case is that it can support 2 80mm fans
at the back of the case, proof to the left.
Now it's time to get ONTO THE POINT
Starting with the WINDTUNNEL.
Here is that 90degree cardboard beam I was talking about.
Not perfectly 90degrees but it'll work sweetly, I'll screw them together (=
Time for some manly work.
Sawing it to shape.
Done!
Installed! (The good thing about cardboard, it's nice
and comfy when squashed into a tight bit)
So that's pretty much it!
I'm expecting heaps for this mod, especially without the PSU on the bottom to obstruct the windtunnel.
I'm going to have to pack away the stuff now, I'm leaving overseas this moment.
So, see ya LATERS.
No comments:
Post a Comment